fedora 23 workstation system requirements

#Fedora 23 workstation system requirements install
#Fedora 23 workstation system requirements upgrade
#Fedora 23 workstation system requirements software

Shutdown Fedora gracefully via the in-system power button.Make user & Password (I made one called Administrator with a lowercase ‘a’ for the username.).Set root password to the Password, MAKE NOTE OF THIS (It must be longer than 8 characters and not a dictionary word, otherwise you’ll run into problems later).Network & Hostname: FOG (or whatever you like).

if you are unsure about how much space is left on the drive to assign to '/', and you have a 500GB drive, you can just type something absurd in like 999 GiB and hit 'update' and the installer will auto adjust that amount to what is available. I'd bump the 'boot' partition up to 2 gigs to be future proof.įedora (and most red-hat installers) auto-adjust partition sizes for you if you go over what is available. Give 'home' just a little for working space. The one thing with using Fedora (or any red-hat based distro) is that the default partitioning isn't optimal for FOG.īasically, you'd give 'swap' the same to double the amount of RAM. From there, you can customize the mount points and their sizes. Say you want to configure them on your own, and then click the “Make partitions automatically” on the left.

‘Automatic partitioning selected’ is not optimal.

set Fedora 21 workstation ISO into the virtual optical drive.įor further details about network setup of Hyper-V: Installing Fedora 21.

#Fedora 23 workstation system requirements software

Ensure v-machine is connected to a working virtual switch (a working internet connection is required during the FOG software installation).

512GB HDD (large size for storing the images on the v-machine).

#Fedora 23 workstation system requirements upgrade

Keep in mind, you can upgrade but not downgrade (unless using snapshots). If you want to check out a newer revision (which I would recommend), simply change the SVN command below to a different number. These instructions should work fine if you're not using Hyper-V maintaining that everything else remains the same.Īlso, these instructions should be good for any SVN above r2922. Notes: These instructions are intended to be followed IN ORDER.Īlthough these instructions were specifically written for r2922 & Fedora 21 (non-updated) inside Hyper-V using Windows Server DHCP, they might help a lot with other newer versions of Fedora although these other versions have not been tested. 3.1 Dell Optiplex 7010 BIOS configurationįOG (r2922) Configuration on Fedora 21 Workstation inside Windows Server 2012 Hyper-V using Windows Server DHCP.3 Client BIOS Settings for auto-boot to network.2 FOG Server Troubleshooting Help (Fedora 21, r2922 & up).1.7 At this point, you should be done with major configuration.1.5 Set the FOG services to start 30 seconds after boot.

#Fedora 23 workstation system requirements install

1.4 Necessary post install configuration.

1.2.7 Configuring existing DHCP server (Windows Server 2012).

1.2.3 Pre-Configuration of Fedora 21 for FOG.

1 FOG (r2922) Configuration on Fedora 21 Workstation inside Windows Server 2012 Hyper-V using Windows Server DHCP.